Required Tools/Parts:

• Phillips Screwdriver
• Wire Stripers
• A splice connector
• 95-99(2^nd Gen) Eclipse Harness
• Some Zip ties

Installation:

1. On the steering wheel column you値l need to remove the 3 Phillips screws underneath and separate the upper plastic and lower plastic covers.The bottom cover will just slip off the ignition switch.
   
   
   
2. On the left side of the column at the end of the ignition switch you値l see the connector.Disconnect it and use the 95-99 eclipse harness.
   
   
   
   
3. Connect the male ends to the female ends and then connect the Turbo Timers wiring harness to the other connection on the 95-99 eclipse harness.
   
   
4. Then run the Turbo Timer harness along the column on the same path the stock wiring is placed and tuck the rest under the dash.
   
   
5. Replace top and bottom halves of column and re-install/tighten Phillips screws.
   
   
6. Now figure out where you want to mount the timer.Once mounted you can plug in the timer to the harness.
   
   
7. The turbo connects to the emergency brake (e-brake) to prevent theft and as a safety to remind you to engage the brake in order to prevent the car from rolling.
   
   
8. To connect the harness to the e-brake, first identify the right wire according to the instructions.Then you値l need to remove the two Phillips screws located in the bottom of the center console storage area.
   
   
9. The rest of the console is secured via clips that give when pulled up on.You値l need to pull the console up and forward slipping it over the e-brake.
   
   
10. After doing this you値l see the wiring/connector to the e-brake.It is only one wire.Just splice into it connecting the wiring harness wire as well.
    
    
11. Zip-tie all your wires out of the way and out of any danger of getting hit or cut.
    
    
12. Replace the center console (reverse of removal) and you can now follow the instructions included with the Timer for proper setup.
    
    

Enjoy your new timer!